Every cutting process of automatic fiber laser coil material cutter reflects the attention of mechanical technicians. Their efforts make the performance of fiber laser cutting not disorderly, safe and efficient. As we all know, the workpiece weighs several hundred kilograms on the workbench, so the optical fiber laser cutting machine is not easy to move. Adjusting and using the automatic edge detection function of the winding of the automatic optical fiber laser cutting machine can save time to adjust the workpiece and promote the efficiency of the machine.

　　用每一种热切削技术，只有少数情况下可以从板的边缘开始，一般情况下，板上必须有一个小孔。在以前使用的激光复合冲压机是先冲孔出孔，然后激光从孔中开始切割。

　　With each kind of hot cutting technology, only a few cases can start from the edge of the plate. In general, there must be a small hole in the plate. In the past, the laser composite punch was used to punch the hole first, and then the laser cut from the hole.

　　脉冲射孔代替爆破射孔，用于小孔的加工。因此，激光能量过于集中在一个小的区域，这使得非加工区域烧焦，导致孔洞变形，影响加工质量。光纤激光切割机此时应在处理程序中将脉冲射孔方式改为爆破射孔方式，解决光纤激光切割机的问题。然而，对于低功率的激光切割机来说，情况恰恰相反。光纤激光切割机

　　Pulse perforation instead of blasting perforation is used to process small holes. Therefore, the laser energy is too concentrated in a small area, which makes the non-processing area burning, leading to hole deformation, affecting the processing quality. In order to solve the problem of fiber laser cutting machine, the pulse perforation mode should be changed to the blasting perforation mode in the processing program. However, for low power laser cutting machines, the opposite is true. Optical Fiber Laser Cutting Machine

　　根据自动卷料工作原理和光纤激光切割机的设计原理，分析了光纤激光切割机产生毛刺的主要原因如下:向上和向下的激光焦点位置是不正确的,你需要做焦点位置测试,根据偏移量的调整,激光输出功率是不够的,需要检查激光发生器工作是否正常,如果正常,然后观察激光的输出控制按钮的值是正确的,试着调整光纤激光切割机,切割速度太慢,需要增加操作控制的线速度。

　　According to the working principle of automatic coiling and the design principle of optical fiber laser cutting machine, the main reasons for burrs in optical fiber laser cutting machine are analyzed as follows: the laser focus position up and down is incorrect, you need to do the focus position test, according to the adjustment of offset, the laser output power is not enough, you need to check whether the laser generator works normally, if it is normal, and then observe the excitation. The value of the output control button of the light is correct. Try to adjust the optical fiber laser cutting machine. The cutting speed is too slow. It needs to increase the linear speed of the operation control.