联系我们
18560023440
王经理：18560023440
地址：山东省德州市齐河县经济开发区齐众大道7号-2车间
业内资讯
木工加工指标参考！
来源：http://www.jmycnc.com 时间：2019-08-30
顾客买了木工,在使用过程中应注意的使用,因为机械设备有很强的风险,通常使用应该做好保护措施,因为不块机械的使用引起的常见,下面列出一些木工指标参考。
Customers buy Woodworking centers, should pay attention to safe use in the use process, because the machinery and equipment have a strong risk, usually use should do a good job of protection measures, because the use of non-block machinery caused by common, the following list of woodworking centers safety indicators for reference.
1、购买木工必须按照轮必须盖,轴必须覆盖和锯条看到封面,封面,飞机(剪切),切一块,装置进料要求,在各种木工机械配置相应的保护装置,尤其是手无寸铁的操作接触危险的地区,应该有保护措施。
1. Purchase of woodworking centers must cover wheels, shafts and saw blades to see the cover, cover, aircraft (shear), cut a piece, safety device feeding requirements, in a variety of woodworking machinery with corresponding safety protection devices, especially in unarmed areas where operational contact is dangerous, there should be safety protection measures.
2、生产噪音、木屑或挥发性有害气体的木工作业，应配备机械操作的噪音、粉尘或通风装置，以确保工人的健康。
2. Wood workshops producing noise, sawdust or volatile harmful gases should be equipped with mechanical noise, dust or ventilation devices to ensure the safety and health of workers.
3,木工刀轴的和电气控制装置,在装卸或更换刀具和维护,可以切断电源和维护断开位置,以防意外接触电源开关或电源突然启动机器,造成人身伤害事故。
3. The center of the woodworking tool axis and the electrical safety control device can cut off the power supply and maintain the disconnection position during loading, unloading or replacing the tool and maintenance, in order to prevent accidental contact with the power switch or sudden start of the machine by power supply, causing personal injury accident.
4. 针对木材加工过程中回弹的危险性，应采用送料装置或隔离刀及防回弹屏，以确保人身。
4. In view of the danger of rebound in wood processing, safety feeding device or isolation knife and rebound-proof safety screen should be adopted to ensure personal safety.
5. 安装正常启停控制装置时，应专门设置控制装置，以备发生事故时紧急停车。
5. When installing normal start-stop control devices, special safety control devices should be set up for emergency stop in case of accident.
6、经常检查线路，确保无漏电，接地线。
6. Check the line regularly to ensure no leakage and grounding wire.
6. Check the line regularly to ensure no leakage and grounding wire.
- 上一篇：光纤切割机的热切割技术！
- 下一篇：影响激光切割机品质的因素有哪些？
