Since the CNC machine has been used to replace the machine in the later stage of the furniture industry, there are many problems that will affect the development of the CNC furniture industry. Four procedures of CNC cutting machine errors and a few points for attention.

主轴的功率大小影响着加工效果，若加工产品需要进行切割开料功能，建议选用大功率主轴，切割速度快，效果好，一般是选用2个6KW大功率的风冷主轴。2个4.5kw风冷主轴、基本的就是伺服电机，有的朋友想要好一些的电机但不想投资过多，则可以选择国产伺服电机。若是本身机器功能，各配置都很高。建议数控开料机也用进口伺服电机。

The power of the main shaft affects the processing effect. If the processing product needs cutting and cutting function, it is recommended to select high-power spindle with fast cutting speed and good effect. Generally, two 6kW high-power air-cooled spindles are selected. Two 4.5kw air-cooled spindles, the basic is servo motor, some friends want better motor, but do not want to invest too much, they can choose domestic servo motor. If the function of the machine itself is comprehensive, each configuration is very high. It is suggested that the imported servo motor should also be used in the CNC cutting machine.

很多数控开料机朋友在数控开料机购买机器时会提到，加工整张板子用吸附台面很好，但有时候加工小材料感觉开吸附泵费电，所以想要吸夹两用的台面，这种台面可以做，大家可能觉得两用的很好，这种认知是错误的！它的吸附效果没有全吸附台面的好！吸附台面是有分区的，非整张的板子可以开单个吸附区域以达到节约用电的目的。

Many friends of CNC cutting machine will mention that it is very good to use adsorption table for processing the whole board when purchasing the machine, but sometimes it costs electricity to open the adsorption pump when processing small materials, so you want a table with dual-purpose suction and clamping. You may think that the dual-purpose table is very good. This kind of cognition is wrong! Its adsorption effect is not as good as the full adsorption table! The adsorption table is divided into zones, and a single adsorption area can be opened for the incomplete board to achieve the purpose of saving electricity.

提到吸附台面，就不得不说说吸附泵的选择了。吸附泵分风冷和水冷数控开料机的吸附泵，风冷的吸附泵噪音较水冷的吸附泵要大一些，但使用水冷的吸附泵的北方朋友们则在秋冬时要注意防冻问题。所以大家可以根据自己所在地域气候情况选择适合的吸附泵。

Referring to the adsorption table, we have to talk about the selection of adsorption pump. Adsorption pump is divided into air-cooled and water-cooled CNC cutting machine. The noise of air-cooled adsorption pump is higher than that of water-cooled adsorption pump, but northern friends who use water-cooled adsorption pump should pay attention to antifreeze problem in autumn and winter. So you can choose the appropriate adsorption pump according to the local climate.