联系我们
18560023440
王经理：18560023440
地址：山东省德州市齐河县经济开发区齐众大道7号-2车间
业内资讯
雕刻机怎样确定主轴转速？
来源：http://www.jmycnc.com 时间：2022-01-21
雕刻机怎样确定主轴转速？
How to determine the spindle speed of engraving machine?
1.在加工时确定主轴转速是非常重要的一个环节，它直接关系到刀具寿命，工件加工效果等。
1. Determining the spindle speed during machining is a very important link, which is directly related to the tool life, workpiece machining effect, etc.
2.确定主轴转速要从材料入手。材料的硬度越高，在加工时主轴转速就越低。材料越粘，加工时主轴转速越高。
2. To determine the spindle speed, first start with the material. The higher the hardness of the material, the lower the spindle speed during machining. The more sticky the material, the higher the spindle speed during machining.
3.确定主轴转速还要从根据使用刀具的直径。使用刀具直径越大，主轴转速越低。
3. Determine the spindle speed according to the diameter of the tool used. The larger the tool diameter used, the lower the spindle speed.
4.确定主轴转速还要根据使用主轴电机的情况。
4. Determine the spindle speed according to the use of spindle motor.
5.从上面的主轴电机功率曲线中我们可以看出，当主轴转速降低时，电机的输出功率也在降低，如果输出功率低到一定程度，就会影响加工，这样反而对刀具寿命和工件效果更加不好，所以，在确定主轴转速时，要注意保证主轴电机有一定的输出功率。
5. From the above spindle motor power curve, we can see that when the spindle speed is reduced, the output power of the motor is also reduced. If the output power is low to a certain extent, it will affect the processing, which will even worse the tool life and workpiece effect. Therefore, when determining the spindle speed, pay attention to ensure that the spindle motor has a certain output power.
6.总的来说，要根据材料，刀具直径和输出功率来确定主轴转速。.在确定主轴转速时一定要根据自己的具体情况进行分析，决定主轴的转速，不要死用建议参数。
6. In general, the spindle speed shall be determined according to the material, tool diameter and output power When determining the spindle speed, we must analyze according to our own specific situation to determine the spindle speed, and do not use the recommended parameters.
本文由石材雕刻机为您提供，我们的网站是：http://www.jmycnc.com/我们将以全心全意的热情为您提供服务，欢迎您的访问
This article is provided by stone carving machine. Our website is: http://www.jmycnc.com/ We will serve you with wholehearted enthusiasm. Welcome to visit
- 上一篇：3050雕刻机主轴温度过高怎么办？
- 下一篇：为什么石材雕刻机在雕刻的时候要加水？
