一、，在Z轴定位的时候，不是让刀碰到材料面，而是移开材料让刀直接碰到台面，碰到就可以了，不要深了，在这个地方Z轴先归零，然后根据你在文泰里设置的切割深 度在提高相应的高度，比如你在文泰设置切割深 度为10，那么在这里我们精 确的让刀提高10，在这再让Z轴归零，这个就是Z轴的原 点了。 根据文泰里的设置深 度，机器下的低点就是我门归零的地方，正好是在台面的上面，这样保证了材料完全刻透而不会刻到台面。

1、 First of all, when positioning the z-axis, instead of letting the knife touch the material surface, move the material and let the knife touch the table directly. Don't touch it too deep. In this place, the z-axis will return to zero first, and then increase the corresponding height according to the cutting depth you set in Wentai. For example, if you set the cutting depth in Wentai as 10, then we will do fine here Let the knife increase by 10, and then let the z-axis return to zero. This is the origin of the z-axis. According to the setting depth of wentaili, the low point under the machine is the place where our door returns to zero, which is just on the top of the table, so as to ensure that the material is completely engraved without being engraved on the table.

二、在文泰里的切割深 度设置为0，然后在存路径的时候高点设置抬刀距离就行了。

2、 Set the cutting depth of wentaili to 0, and then set the tool lifting distance at the high point when saving the path.

三、还可以使用微动开关进行上下限位，每轴2个限位开关，做硬件限位心理有个底 这样无论怎样都不会撞台面了。或者使用对射光槽，但如果没有挡屑装置，对射很可能因碎屑的进入而频繁出麻烦。

3、 You can also use the micro switch for the upper and lower limit, 2 limit switches for each axis, so that there is a bottom for the hardware limit psychology, so that no matter how it will not hit the table. Or use the opposite light groove, but if there is no chip blocking device, the opposite light may be in trouble frequently due to the entry of debris.

5、保存精雕路径

5. Save the carving path

选中做好的路径——点击【保存精雕路径】——点击【查找】找到要保存的位置，文件类型选择(*.nc)命名后点击【保存】——抬到距离一般设置5-10——点击【确认】

Select the path you want to save - click save path - click find to find the location you want to save. Select the file type and name it. Click Save - move to the general distance setting of 5-10 - click OK

以上就是石材雕刻机厂家给大家分享的雕刻机操作技巧 木工雕刻机如何操作不伤台面的详细解答，不知道大家对小编的介绍是否满意。如果您还想了解更多相关 方面的精彩内容，还请您继续关注我们的版块!

The above is the stone carving machine manufacturers to share the carving machine operation skills, wood carving machine how to operate without damaging the table, I do not know if you are satisfied with the introduction of Xiaobian. If you want to know more about the wonderful content, please continue to pay attention to our section!