The engraving programming software of the aluminum plate engraving machine programs the engraving path: for example, for engraving text, first use the software to layout, and then use 2D, 3D and cutting. Enter the parameters such as depth, overlap rate and line spacing in the pop-up dialog box and calculate it on the computer. When processing relief, first use ArtCAM or fine engraving to generate relief from file or model image, determine the size, input various processing parameters, and the computer starts calculation. When generating paths, colored lines are generated for words or models.

输出雕刻路径及输入雕刻机控制系统软件：在文泰、精雕、ARTCAM等软件输出文件中，如果雕刻机控制系统不能支持该格式，也需要转换。常见的程序格式是nc、mmg等。

Output engraving path and input engraving machine control system software: in Wentai, Jingdiao, ArtCAM and other software output files, if the engraving machine control system cannot support this format, it also needs to be converted. The common program formats are NC, MMG, etc.

检查机器并正确固定工件：检查机床上是否有碎片，尤其是石粒、大面积的石粉、砂等，注意清理，否则容易影响材料的平面度。将工件按排版编程软件里的放置方向，看横向还是竖向放置材料。注意材料和机器走向轴方向平行，不要放偏了。使用压板固定材料，一般固定方式有压力和上二。用压板按压时，请注意不要按压材料的加工部分，以防止机械碰撞或刀具碰撞。

Check the machine and fix the workpiece correctly: check whether there are fragments on the machine tool, especially stone particles, large-area stone powder, sand, etc. pay attention to cleaning, otherwise it is easy to affect the flatness of the material. Place the workpiece according to the placement direction in the typesetting programming software to see whether the material is placed horizontally or vertically. Note that the material is parallel to the axis of the machine, and do not deviate. The pressing plate is used to fix the material. The general fixing methods are pressure and upper two. When pressing with a pressing plate, be careful not to press the machined part of the material to prevent mechanical collision or tool collision.

确定工件坐标系原点，也就是我们常说的对刀。将机器的每个轴的起源与原始点对齐，然后将数据返回到零或输入相应坐标的坐标。

Determine the origin of workpiece coordinate system, that is, we often say tool setting. Align the origin of each axis of the machine with the original point, and then return the data to zero or enter the coordinates of the corresponding coordinates.

检测喷水、水循环，调节机械转速和进给速度，在铝板雕刻机控制系统中进行模拟。

Detect the water spray and water circulation, adjust the mechanical speed and feed speed, and simulate it in the control system of aluminum engraving machine.

启动雕刻机。加工完成。确认铝板雕刻机的雕刻效果是否满意，以及是否需要补刀。

Start the engraving machine. Processing is complete. Confirm whether the engraving effect of the aluminum plate engraving machine is satisfactory and whether it needs to repair the knife.