The standard stone engraving machines and tombstone engraving machines are dual cooling. On the one hand, because the stone material is hard, it is necessary to water-cooling the cutter head when working. On the other hand, it is water cooling the spindle to prevent the spindle temperature from being too high, which plays a certain role in protecting the spindle. However, if the customer does not pay attention to or do not follow the training steps, there will be no water dry burning phenomenon, causing serious damage to the machine itself.

Stone carving machine

一，石材雕刻机主轴干烧更容易导致的就是主轴发热过度,温度过高导致烧掉。一般主轴烧掉后,就得需要把坏的返厂维修。然后修好再从工厂发回来,这样一来一回的周期大约1周左右,会严重耽误正常加工工期，如果客户那边着急要订单的话，会造成很大的损失。所以说客户在加工的时候，一定要按照工厂技术员的培训操作，保证机器的正常使用，延长机器的适用周期。

1、 Stone engraving machine spindle dry burning is the most easy to lead to excessive spindle heating, high temperature leading to burning. Generally, after the spindle is burned, it is necessary to return the damaged one to the factory for repair. Then it is repaired and then sent back from the factory. The cycle is about one week, which will seriously delay the normal processing period. If the customer is in a hurry to order, it will cause great losses. Therefore, when processing, customers must follow the training of factory technicians to ensure the normal use of the machine and extend the applicable period of the machine.

二，如果石材雕刻机的主轴没有通水冷却,就会一直处于持续高温发热状态。容易导致主轴出现抖动或者错位,雕刻忽快忽慢,不稳定的现象。一方面会使精度会受到影响，另一方面主轴错位会使得雕刻样品错位，雕刻出的样品自然漏洞百出,非常不精细。

2、 If the main shaft of the stone carving machine is not cooled by water, it will always be in a state of continuous high temperature heating. It is easy to lead to spindle shaking or dislocation, carving fast and slow, unstable phenomenon. On the one hand, the accuracy will be affected, on the other hand, the spindle dislocation will make the engraving sample dislocation, carving out the sample naturally full of holes, very not fine.